Pemko R.75FMR_ ADA Compliant Modular Ramp Flush Threshold Assembly with Miter Returns – 9-1/4″ Wide x 3/4″ High

Pemko R.75FMR_ 3/4″ H x 9-1/4″ W ADA Compliant Aluminum Interlocking Ramp with Miter Returns

Assemblies accommodate 1⁄2″ to 21⁄4″ floor offsets in meeting the 1:12 slope requirements of the “Americans with Disabilities Act”.

• 9-1/4″ wide x 3/4″ offset
• Assemblies are supplied with #10 stainless steel wood screws
• Assemblies are provided NET length
• Cast aluminum “wings” fit into each end of a modular ramp threshold assembly, and are fastened to the ramp mid sections with self-tapping machine screws.
• Mill finish (optional Pemkote skid resistant finish)
• Pemkote™ is highly recommended for all threshold assemblies, especially exterior conditions where moisture may be present. Pemkote Meets Requirements of: ASTM D 2047 & Federal Specifications P-F-430C.

• Pemko modular ramps are ADA compliant as they meet the standard of a 1:12 slope.
• The wings for these ramps do not meet the ADA 1:10 slope requirements.
• In order to make the sides of the ramp ADA compliant, they must follow the ADA guidelines as follows:
• Section 4.7.5 “Sides of Curb Ramps”:
• If a curb ramp is located where pedestrians must walk across the ramp, or where it is not protect by handrails or guardrails, it shall have flared sides; the maximum slope of the flare shall be 1:10.
• Section 4.8.7 “Edge Protection”:
• Ramps and landings with drop-offs shall have curbs, walls, railings, or projecting surfaces that prevent people from slipping off the ramp.
• Curbs shall be a minimum of 2″ high.
• Pemko recommends the use of mitered returns to seal up the side of the ramp.
• Otherwise, we recommend filling and feathering the threshold ends with grout (do not leave threshold ends open).

Finishes

• R.75FMRA: A – Mill Finish Aluminum Aluminum
• R.75FMRAK: AK – PemKote Skid Resistant Surfacing Aluminum

This product is fabricated to order and is not returnable or refundable.