Command Access MLRK1-COR Motorized Latch Retraction Kit for Corbin Russwin 4000/5000 & Yale 7000 Series Exit Devices

Command Access MLRK1-COR Motorized Latch Retraction Kit, for Corbin Russwin ED4000/ED5000 & Yale 7000 Series Exit Devices (Field Installation)

The MLRK1-COR is a cost-effective and straightforward way to upgrade your Corbin Russwin 4000/5000 & Yale 7000 series device to motor-driven latch retraction in the field. UL Listed + 3-Year Warranty.

The MLRK1-COR is a high quality, cost-effective method of converting a Corbin Russwin 4000/5000 & Yale 7000 series device to an electrified motor-driven latch retraction exit device. All our kits retract not just the latch/latches but the push pad too. Allowing electronically dogged devices to remain in a push/pull state for as long as it is desired. Patent Pending Push to Set (PTS) Technology allows for an easy post-installation adjustment of the latch/latches. Last but not least, it features our motor module with built-in audible diagnostics & equipped with 2 different torque settings from energy-conscious, to High Torque to get the tough jobs done!

• Works with all Corbin Russwin ED4000/ED5000 & Yale 7000 Series devices
• Fast, Quite, Smooth & Strong!
• Patent pending Push to Set (PTS) Technology
• MM4S Smart Module: On board diagnostics with audible feedback for adjustment and power issues
• Low Current Draw – Field switchable to “High Torque” mode
• Up to 300’ wire run with 2-18ga wire – Long wire runs provides installer with convenience of placing the Command locking hardware power supply in a centralized location; i.e. the same closet as the access control panel
• Electric dogging rated for continuous duty – Auto reengage if push pad is pulled from dogged position
• UL Listed
• 3-Year “No Hassle” Warranty

Specifications:

• Voltage Range – 24 TO 28 VDC
• System protection – unit shutdown when voltage exceeds 28 VDC
• Standard – average current peak: 900MA, average current hold: 215MA
• PTS adjustment – approx. 1/4″
• Wire Run: 300′ with 18ga wire
• Cutdown details: 36” – 4” from end cap, 48” – 10” from end cap
• Built-in (REX) Request-to-Exit kit optional